Line Locators Inc.

G.P.R. ground-penetrating-radar may be used to locate buried utilities, objects and or voids (depending on soil conditions). GPR is also used in concrete scanning for locating rebar, post-tension & conduits. When scanning in congested areas, (many buried targets with upper and lower rebar mats, conduits and post-tension cables), it is recommended that a 3D scan be performed due to the fact that the upper targets will mask the lower targets. GPR concrete scanning can not distinguish the difference between a single rebar and a single post-tension cable. It can only detect the centers and approximate depth. Line Locators Inc. uses other equipment to help verify post-tension cables and power conduits (power must be on and running though line to be detected). GPR data, with notice, can be saved for post-processing.

UTILITY, GEO-SCAN AND FAULT LOCATION: An electronic signal is induced on the utilities. Line Locators Inc. marks the area with the highest reading. Line Locators Inc. must have a utility or (line) on which to induce the signal. If Line Locators Inc. does not find any signal, or, if there is no line to apply a signal on, Line Locators Inc. will not be responsible for undetected or damaged lines. A sonde type transmitter on the end of a fiberglass push-rod is used to locate non-metallic drain lines and or duct banks. Depth readings are approximate.

LEAK DETECTION: Line Locators Inc. uses an electronic listening device and an electronic helium detector to find leaks. Line Locators Inc. marks the area with the highest reading of helium and/or the highest acoustical reading on the target line. Pool and spa leaks are located this way as well. Leak Detection is more an art than a science. Many factors can affect the marked location of leaks; soil conditions (back-fill used), depth and size of leak.

VIDEO PIPELINE INSPECTION: Line Locators Inc. visually inspects and locates pipe as well as any problems or points of interest with depths based on a good signal from a sonde type transmitter.

CALL FOR RATES AND SCHEDUAL (1-888 256 7917)

Payment or PO # is due at completion of job.

NOTE: If any equipment is lodged due to open lines, damaged lines or congested lines or fittings, you will be billed at our normal rate to remove equipment, or you can arrange to remove the equipment in a timely fashion, with no damage to the equipment and at no cost to Line Locators Inc. All locations must be excavated by hand to verify line location! Line Locators Inc. is not responsible for hit targets that were masked or undetected.

Download the Waiver and Approval Document



About Us Services Links Contact Home
» Contact Us For A Quote
GPR (ground penetrating radar) GEO SURVEY LEAK DETECTION UTILITY LOCATION VIDEO PIPE LINE INSPECTION INFRARED IMAGING FAULT LOCATION CONCRETE SCANNING & MORE... read more GENERAL CONTRACTORS UNDERGROUND CONTRACTORS MAINTAINENCE ENGINEERS ENVIRONMENTAL ENGINEERS STRUCTURAL ENGINEERS HOME INSPECTORS PROPERTY MANAGERS ELECTRICAL CONTRACTORS PLUMBING CONTRACTORS	Wavier and Apporval G.P.R. ground-penetrating-radar may be used to locate buried utilities, objects and or voids (depending on soil conditions). GPR is also used in concrete scanning for locating rebar, post-tension & conduits. When scanning in congested areas, (many buried targets with upper and lower rebar mats, conduits and post-tension cables), it is recommended that a 3D scan be performed due to the fact that the upper targets will mask the lower targets. GPR concrete scanning can not distinguish the difference between a single rebar and a single post-tension cable. It can only detect the centers and approximate depth. Line Locators Inc. uses other equipment to help verify post-tension cables and power conduits (power must be on and running though line to be detected). GPR data, with notice, can be saved for post-processing. UTILITY, GEO-SCAN AND FAULT LOCATION: An electronic signal is induced on the utilities. Line Locators Inc. marks the area with the highest reading. Line Locators Inc. must have a utility or (line) on which to induce the signal. If Line Locators Inc. does not find any signal, or, if there is no line to apply a signal on, Line Locators Inc. will not be responsible for undetected or damaged lines. A sonde type transmitter on the end of a fiberglass push-rod is used to locate non-metallic drain lines and or duct banks. Depth readings are approximate. LEAK DETECTION: Line Locators Inc. uses an electronic listening device and an electronic helium detector to find leaks. Line Locators Inc. marks the area with the highest reading of helium and/or the highest acoustical reading on the target line. Pool and spa leaks are located this way as well. Leak Detection is more an art than a science. Many factors can affect the marked location of leaks; soil conditions (back-fill used), depth and size of leak. VIDEO PIPELINE INSPECTION: Line Locators Inc. visually inspects and locates pipe as well as any problems or points of interest with depths based on a good signal from a sonde type transmitter. CALL FOR RATES AND SCHEDUAL (1-888 256 7917) Payment or PO # is due at completion of job. NOTE: If any equipment is lodged due to open lines, damaged lines or congested lines or fittings, you will be billed at our normal rate to remove equipment, or you can arrange to remove the equipment in a timely fashion, with no damage to the equipment and at no cost to Line Locators Inc. All locations must be excavated by hand to verify line location! Line Locators Inc. is not responsible for hit targets that were masked or undetected. Download the Waiver and Approval Document
Contact Us Anytime by phone 888.256.7917 or by email.
© 2006 LINE LOCATORS, INC. ALL RIGHTS RESERVEDABOUT US \| SERVICES \| LINKS \| CONTACT \| HOME

Wavier and Apporval